Colecția instituțională: Recent submissions

  • SAFTA, Ioana Lavinia; SABĂU(POPA), Andrada-Ioana; MUNTEAN, Neli (MDPI (Basel, Switzerland), 2021)
    Creative accounting has its background since early studies in 1975, until the present time. It continues to be a subject of great interest for the companies and interested parties. Thus, the current paper will aim to answer ...
  • AMBROS, Tudor; BURDUNIUC, Marcel (IEEE, 2016)
    The paper is devoted to the analysis of concentrated windings, which are lately used in electric machines of alternative current.
  • AMBROS, Tudor; URSATII, Nicolae; BURDUNIUC, Marcel (Asociatia Generala a Inginerilor din Romania, 2011)
    Au fost analizate posibilităţile de realizare a unui generator sincron cu magneţi permanenţi si întrefier neted. S-a dovedit analitic, dispariţia armonicilor de ordin superior din curba de variaţie a inducţiei magnetice ...
  • AMBROS, Tudor; DIMOV, Diana (Ştefan cel Mare University of Suceava, Romania, 2009)
    L’analyse des générateurs à flux magnétique axial excités par des aimants permanents est réalisée pour sélécter une construction technologique simple fiable est efficiente. En application la méthode de l’élement fini dans ...
  • AMBROS, Tudor (Asociatia Generala a Inginerilor din Romania, 2011)
    În lucrare este prezentata repartizarea liniilor magnetice produse de curenţii centurii nucleare terestre si a centurilor de radiaţie Van Allen si acţiunea reciproca dintre aceste câmpuri. Sunt înaintate ipoteze referitoare ...
  • AMBROS, T.; BURDUNIUC, M.; DEACONU, S. I.; RUJANSCHI, N. (IOP Publishing, 2018)
    The paper presents the analysis of various constructive schemes of synchronous electromechanical converters with permanent magnets fixed on the rotor and asynchronous with the short-circuit rotor. Various electrical stator ...
  • AMBROS, Tudor; IAZLOVEŢCHI, Leonid; BURDUNIUC, Marcel (Ştefan cel Mare University of Suceava, Romania, 2006)
    It was analyzed the dependence of the electromotive voltage and the voltage decline of the synchronous engine on the charge angle and the power factor. It has been proved that the electromotive voltage has a minimal value ...
  • KIORSAK, Mihail; KALININ, Leo; AMBROS, Tudor (Stefan cel Mare University of Suceava, Romania, 2007)
    One of the perspective technical decisions in the field of management of modes of the electrical networks and systems are the Flexible Alternating Power Transmission Systems (FACTS) or Power Controllers. Most perspective ...
  • AMBROS, Tudor (Academia de Ştiinţe a Moldovei, 2011)
    S-a dimensionat structura internă a Terrei în vederea calculului câmpului magnetic terestru. În baza datelor iniţiale şi ipotezelor acceptate, s-a elaborat modelul Terrei şi centurilor de radiaţie. Prin aplicarea metodei ...
  • DOBRESCU, Cornelia-Florentina; BRĂGUŢĂ, Eugeniu (Springer Nature Switzerland, 2017)
    The present paper is aimed to improve the compaction technology using rheological models for describing soil response parameters under impact loading of vibrating rollers.
  • BRAGUŢA, Eugeniu ("Dunarea de Jos" University in Galati, 2018)
    Acestă teză de doctorat are ca scop, aprecierea instrumentală și informatică a legităților structurale și funcționale care conduce interacțiunea dintre echipamentul vibrator și materialul compactat având ca scopul formularea ...
  • PODBORSCHI, V.; VACULENCO, M. (Springer Nature Switzerland, 2005)
    The study of nature forms, of cycles of existence of natural products as a source of inspiration and the familiarization for specialists, designers, constructors, technicians in the designing of a new generation of industrial ...
  • ГРАБКО, Д. З.; ШИКИМАКА, О. А.; ЕЛИША, М.; САВА, Б.; БОРОЙКА, Л.; ХAРЯ, E.; ПЫРЦАК, К.; ПРИСАКАРУ, А.; ФЕРАРУ, И.; УРСУ, Д. (Institutul de Fizică Aplicată al AŞM, 2012)
    Изучены морфология и микроструктура поверхности силикат-фосфатных пленок, нелегированных и легированных неодимом, а также прочностные характеристики (модуль Юнга и твердость) как пленок, так и композитных структур SiO 2-P ...
  • PYRTSAC, C. M. (Institutul de Fizică Aplicată al AŞM, 2016)
    In this paper the Cu/MgO and Cu/Si CSs were selected for the investigation of the plasticity index behavior. The nano-microhardness of the MgO and Si single crystals using as a substrate is 10-12 times higher in comparison ...
  • GRABCO, D.; SHIKIMAKA, O.; ELISA, M.; SAVA, B.; BOROICA, L.; HAREA, E.; PYRTSAC, C.; PRISACARU, A.; DANITSA, Z.; FERARU, I.; URSU, D. (Institutul de Fizică Aplicată al AŞM, 2012)
    The SiO2-P2O5 films demonstrated quite good adhesive behavior. At the same time less cohesion strength ’film-substrate’ was revealed for the composite structure SiO2-P2O5-Nd2O3/SLG. A further research will be directed at ...
  • CHIŞCA, D.; CROITOR, L.; COROPCEANU, E. B.; KRAVTSOV, V. Ch.; BOUROSH, P.; GRABCO, D.; PYRTSAC, C.; FONARI, M. S. (Institutul de Fizică Aplicată al AŞM, 2014)
    Mechanical propeties of metal-organic materials (MOMs) deserve growing attention since they are essential variables for a majority of possible applications. The nanoindentation allows estimating the stability liinits of ...
  • CROITOR, Lilia; GRABCO, Daria Z.; COROPCEANU, Eduard B.; PYRTSAC, Constantin; FONARI, Marina S. (The Royal Society of Chemistry, 2015)
    The mechanical features of catena-{(μ2-adipato-O,O′)-bis(pyridine-4-aldoxime)-copper(II)} were studied by the nanoindentation technique under different loads. The newly synthesised metal–organic material 1, with a ...
  • PÎRŢAC, Constantin (Institutul de Fizică Aplicată al AŞM, 2018)
    Scopul: Evidenţierea mecanismelor extrem de complicate de interacțiune ale filmelor de diferite grosimi cu substrat la acțiunea sarcinii concentrate, şi anume la nanomicroindentare, care fac parte din cele mai importante ...
  • GRABCO, D. Z.; PYRTSAC, C. M.; SHIKIMAKA, O. A. (Institutul de Fizică Aplicată al AŞM, 2018)
    In recent years, special attention has been paid to the development and fabrication of new materials, in particular to the coated systems (CS). From a practical point of view, the relaxation processes under nanoindentation ...
  • GRABCO, D.; SHIKIMAKA, O.; ELISA, M.; SAVA, B.; BOROICA, L.; HAREA, E.; PYRTSAC, C.; PRISACARU, A.; DANITSA, Z. (Institutul de Inginerie Electronică şi Nanotehnologii "D. Ghiţu", AŞM, 2014)
    Intensive research into the various types of glassy materials (GMs) is being conducted due to their widespread application in many areas of modern engineering. However, despite the progress made in understanding the internal ...

Search DSpace


Browse

My Account